AM Amp 2400 Controller

Requirements: None
Limitations: None

Before RTXI 3.0.0

Controls the AM Amp 2400 amplifier by scaling the gains on the analog input/output channels and sending a mode telegraph to set the amplifier mode (custom).

Also enables scaling of custom AO offsets based on the gains of the selected amplifier mode.

Input

1. input(0) - I=0 Input from AI : Empty signal from analog input for 'calibrating' the input channel for I=0.
2. input(1) - I=0 Input from AO : Empty signal from analog output for 'calibrating' the output channel for I=0.

Output

1. output(0) - Mode Bit 1 : Bit 1 of signal sent to amplfier
2. output(1) - Mode Bit 2 : Bit 2 of signal sent to amplfier
3. output(2) - Mode Bit 4 : Bit 4 of signal sent to amplfier

Parameters

1. Input Channel - Input channel to scale (#)
2. Output Channel - Output channel to scale (#)
3. Amplifier Mode - Mode to telegraph to amplifier
4. Probe Gain - Gain - HIGH (10 MOhm) or LOW (10 GOhm)
5. AI Offset - Offset the amplifier scaling (entered manually or computed based on current amplifier mode)
6. AO Offset - Offset the amplifier scaling (entered manually or computed based on current amplifier mode)

States

RTXI 3.0.0

The plugin has been completely redesigned to not require a real-time loop to control the amplifier. Instead the plugin provides convenience parameters and control system control settings that are relevant to the amplifier. In particular it is a shortcut to set system control analog and digital inputs, so the user does not require to open the system control plugin to enable and modify channels, as well as 'set DAQ' button to set the configuration.