SUPPORT_DEVICE my GRII omits "RICOH"

[epadepa]

I had to remove the RICOH string from the SUPPORT_DEVICE to get my GRII with 3.0 firmware to work. SUPPORT_DEVICE = ['GR II', 'RICOH GR III']

[clyang]

Can you elaborate on this issue with more detail please?

[johnmaguire]

Just wanted to chime in and say I don't have a GR II but I'm not sure how this script would work with it...

1. DEVICE defaults to "RICOH GR II" - https://github.com/clyang/GRsync/blob/master/GRsync.py#L24
2. DEVICE is overridden and set to props["model"] but must be one of ['RICOH GR II', 'RICOH GR III'] - https://github.com/clyang/GRsync/blob/master/GRsync.py#L173-L178
3. The non-GR III route is used only if DEVICE is "GR2" (this should be == but regardless it's not clear how this would ever be set to "GR2") - https://github.com/clyang/GRsync/blob/master/GRsync.py#L91-L94

I don't have a GR II to test with, just perusing this code for a project of my own. I believe @epadepa was stating that his props["model"] on his camera is set to GR II which isn't allowed due to the check in step #2 above.

Even after the change @epadepa made, it'd be using the "GR III route" - which is likely the same for any GR device on a newer firmware.

[vardai]

My GR II also refers to itself as "GR II" rather than "RICOH GR II", thus the script comes to a halt before even starting any transfer at all. Firmware is 3.0.