Loading saved courses?

[theRealPDXMike]

Is there a way to load a saved CP course on a different piece of equipment? I seem to remember CP for FS19 you could do this, but either it isn't currently implemented or I'm going about it all wrong. What I'm trying to do is harvest a field with a combine leaving a straw swath, then come back later with a forage wagon or a baler to pick up the straw. Since the width is the same the second machine should be able to just load the same course as the combine.

[Redster999]

I just did it. Had a saved course in No mans land for harvester. Loaded the course with a smaller cultivator and clicked the course in the mini hud. The tool settings had changed. This would be nice for the baler, but ofcourse for my smaller cultivator i needed to generate a new route. And it worked, also with the same starting point

[Tensuko]

Save course -> load course.
Just like normal :)

[theRealPDXMike]

Ok, got it working with the baler. It does not work with the forage wagon. My problem getting it to load earlier was that I didn't clear the current course before trying to load the new course.
The forage wagon will load the course, but won't start the worker.

[mario-fehr]

Ok, got it working with the baler. It does not work with the forage wagon. My problem getting it to load earlier was that I didn't clear the current course before trying to load the new course.
The forage wagon will load the course, but won't start the worker.

Yes because forage wagon worker is not implemented yet